Aprilia RS250 · 3D simulator

Loading 3D bike Preparing model…

View

Camera & point

camera: loading…

No point selected

Wheel rotation

Front wheel 0° Rear wheel 0° Wheel pivots load with the bike.

Bike object animation

Part

Parts rebuild from the loaded GLB. Rotations use each object's Blender origin.

No object selected

Animation tests

Movement state 0%

Stage 1 Heading 0° Tilt 0° Amount 0° Preview 100%

Enable stage 2

Stage 2 Heading 90° Tilt 0° Amount 0° Preview 100%

Choose a part to inspect its exported origin.

Sound test loops

Solo any live simulator layer. Each selection loops until you stop it or select another.

Audio tests load after the first click.

Story reaction clips

Smoke test

Using live simulation smoke.

Oil test

Using live simulation oil.

Bike controls

Use the physical controls below, open Story for a guided situation, or edit the bike’s condition directly.

Throttle Closed Clutch Pulled in Choke 0% Gear

Live model assessment

Reads the current engine condition. The sustained-start estimate assumes a held electric start and a battery that can maintain cranking speed; idle reports the real loading trend, not a timer.

Start now: —
Long crank: —
Idle trend: —
Main cause: —
Recovery: —

Manual engine state

Set the bike directly. Stories read these exact live values.

Outside temp 18°C Engine temp 18°C Time since started 1 day Last ride Steady Last warm-up Partly warmed Warm idle 1250 rpm Oil mixer 1.8% Battery 12.7V Battery health 97% Fuel in carb 0% Flooding 0% Left-cylinder plug 0% Right-cylinder plug 0% Left cylinder Right cylinder Carb condition 0% Oil residue 14% Left-cylinder compression 142 psi Right-cylinder compression 142 psi

Jump start connected